International ICZ 4H
Laminator
Machines designed for lamination using heat-activated or cold adhesive materials up to a thickness of 100 mm and widths of 1300, 1600, and 2300 mm. The machines serve for laminating, rewinding, and cutting materials.
Machines designed for lamination using heat-activated or cold adhesive materials up to a thickness of 100 mm and widths of 1300, 1600, and 2300 mm. The machines serve for laminating, rewinding, and cutting materials. Each operation can be performed separately or together. The machine is equipped with a foot switch that facilitates work on the machine. The maximum processing speed of the material is 20 m/min. Machines are designed with the highest regard for operator safety, and all hazardous parts are covered during operation. The machines are manufactured with a modular structure and can be adjusted based on requirements of the customer.
Options
- External unwinder + machine + output conveyor
- External input conveyor + machine + output conveyor
- External unwinder + external input conveyor + machine + output conveyor
- External unwinder + external input conveyor + machine + output conveyor + external winder
Wide variation of ICZ 4H Laminators
Type of the machine | working width of the machine |
ICZ 1300 4H | 1 300 mm |
ICZ 1600 4H | 1 600 mm |
ICZ 2300 4H | 2 300 mm |
Units inside of the machine
Lamination unit
- Rolls with rubberized surfaces.
- Possibility to set the temperature of individual rolls up to 100°C.
- Adjustable gap between rolls from 0 to 100 mm.
- Material processing speed from 0 to 20 m/min.
Unit of longitudinal cut
Pneumatic knives
- Cut against a hardened roller.
- Option to choose the number of knives.
- Knife pressure is pneumatic.
Round blades
- Cut against rubber covers on the roller.
- Rubber covers can be easily replaced when worn out.
- Adjustable blades height.
- Option to choose the number of blades.
Puller
- Device designed for material tightening between units.
- Prevents material slippage.
- Used for material movement inside of the machine.
Transverse cutting unit – Cross cut
- Possibility to use a pressure bar.
- Cut performed by a circular rotating knife.
- Possibility to set knife lubrication and sharpening.
- Adjustable sheet length.
Rewinders
- Adjustable material tightening force.
- Adjustable speed for tightening of material.
- Two rewinders in the machine.
- Maximal material weight 100 kg.
- Maximal material diameter 600 mm.
- Swing-out shaft with a ruler for easier material alignment.
- Shaft placed in a swing-out chucks.
- Clamp for 3″ cores.
Unwinders
- Adjustable brake force for unwinding.
- Adjustable speed for tightening of material.
- Two unwinders in the machine.
- Maximal material weight 100 kg.
- Maximal material diameter 600 mm.
- Swing-out shaft with a ruler for easier material alignment.
- Shaft placed in a swing-out chucks.
- Clamp for 3″ cores.
Entrance table
- It serves to guide the material into the machine.
- Ensures consistent material entry angle.
- Prevents material ripple before lamination.
- Possibility to tilt the table.
External Unwinder
- Clamp for 3“ cores.
- Maximal material diameter 1200 mm.
- Maximal material weight 800 kg.
- Shaft with a ruler for easier material alignment.
- Shaft placed in a swing-out chucks.